Symetrix xControl Manual de usuario descargar pdf (Pagina 3)

Basic Hookup

QUICK START GUIDE: SymNet xControl

PRIMARY

SECONDARY

DANTE NETWORK AUDIO

ARC-2e

DOWN

ARC

ETHERNET

The RJ45 connectors labeled “ARC” are only for use with the ARC series of remotes.

DO NOT plug the ARC connectors on Symetrix products into any RJ45 connector labeled “DANTE”, or “ETHERNET” .

The “ARC” RJ45 connectors on Symetrix products can carry anywhere from 6 to 24 VDC which can damage Dante and Ethernet circuitry.

Conﬁguring IP Parameters

Locating Hardware

Discovery of, and connection to, xControl hardware is done

with the Locate Hardware dialog found under the Hardware

menu or by clicking the Connection Status box in the bottom

left corner of the xControl icon.

The Locate Hardware dialog will scan the network and list available units with DHCP IP addresses. Select the xControl unit to assign a static

IP address to and click the Properties button. To assign the xControl a static IP address, select “Use the following IP address” and enter the

appropriate IP Address, Subnet mask and Gateway. Click OK when finished. Next, back in the locate hardware dialog, ensure the xControl

device is highlighted and click “Select Hardware Unit” to connect the selected xControl on the network to the xControl in the SymNet

Composer Site File. Close the Locate Hardware dialog.

- Or -

IP Configuration with Composer

Direct connection to DSP

using PoE injector.

Connection to non-PoE

switch/network using

PoE injector.

Connection to PoE

switch/network without

PoE injector.

Powering and Hookup to the Network

1 2 3 4

Sin comentarios

Symetrix xControl Manual de usuario Pagina 3